Note: for notations like ‘B4’ please refer overview of spinstudio interface. Open Spinstudio software Select the corresponding template (B4) to generate a new project or load the desired project generated previously.…
In this phase, changing the name of previously generated projects are demonstrated in Spinstudio. Open Spinstudio software Find the previously generated projects in the list ‘Load recent project’ below and…
In this phase, a new project from ‘Oriented Fiber Deposition’ template is created in Spinstudio. Note: for notations like ‘B4’ please refer overview of spinstudio interface. Open Spinstudio software. Select “Oriented…
Caution! If you are about to install the rotational drum collector for the first time, please refer to the ‘Rotational Drum Collector – First Time Installation‘ guide. Before the first…
Once a project has been opened or created, spinstudio opens the Settings application. If the system is properly connected, Each powered system is indicated with green checkmark (here, spincube and…
If you are experiencing connection problems with spincube after a project was opened or created, you may reconnect spincube. Identifying a connection problem Before proceed, check your system’s connection status.…
The Historical Data panel’s Timeline allows you to freely choose which part of your measurement you want on the graph. Zoom in and analize key parts of your data easily…
Select Dashboard (1) on the Menu bar. Select the cubePump module on the list, then right click (2) and place it on the Dashboard. Make sure the correct module is…
To set up the camera module go to Settings in the Menu bar (1). Select camera from Your systems and choose camera from the module list (2). The camera framerate (3) is set…
To set up the cubepump module go to Settings in the Menu bar (1). Select spincube from Your systems and choose cubePump from the module list (2). If you are continuing your…