Installing the high voltage cable

Note: for notations like ‘D2’ please refer to Overview of system components.

High voltage cable cannot be detached from the spincube power unit.
Follow the steps to install the high voltage cable in the spincube chamber:

1. Locate the cable stopper at the free end of the energy chain which encloses the red high voltage cable. Release the C-clip of the cable stopper.
2. Push the free end of the high voltage cable through the hole located at the side of the spincube chamber D2.
3. Pull in the cable from the inside of the chamber until the cable stopper reaches the hole D2. Gentle push the cable stopper through the hole D2. Push in the cable in the energy chain which is located inside the chamber. Push the crocodile clip through the dedicated hole in the droplet tray holder G5.
4. From inside of the chamber lock the cable stopper by pushing back the C-clip of the cable.