Overview of system components

The following components can be found on the sides of A2 spincube chamber:
C1 – Emitter-collector distance adjustment handwheel
D1 – Collector electrical connector
D2 – High voltage cable bushing
E1 – spincube pump
E2 – Teflon tube bushing

The following connectors are located on the backside of A1 and A2 units:
F1 –Ethernet connector for GigE camera
F2 – Chamber Control Connector
F3 – RJ-45 LAN ethernet connector
F4 – USB-A connector
F5 – Reset button
F6 – 12V power supply connector
F7 – Collector electrical connector
F8 – Mains power connector
F9 – spincube power on switch
F10 – Chamber Control Connector
F11 – Protecting Earth terminal
F12 – High voltage cable
F13 – Emergency stop button
F14 – HydroDrive tubing
F15 – Oil reservoir/refill tank
F16 – HydroDrive valve for air discharge/oil refill
F17 – Protecting Earth terminal for spincube pump modules
F18 – USB connector for spincube pump modules
F19 – Mains power connector for spincube pump modules
F21 – spincube pump droplet tray
F20 – Mains power switch for spincube pump modules
F22 – spinsplit IoT box
F23 – USB hub

Once A3 chamber door is opened one can locate the following components inside the chamber:
G1 – Interchangeable collectors (rotational drum collector/flat plate collector)
G2 – Emitter platform
G3 – Emitter nozzle and needle holder
G4 – Fastener screws
G5 – Droplet tray holder
G6 – GigE camera module
G7 – Protective glass
G8 – HydroDrive pressure sensor
G9 – Temperature and humidity sensor (the small one)
G10 – HydroDrive stand
G11 – HydroDrive cartridge
G12 – Emitter distance indicator