Set output voltage

Output voltage can be adjusted either by using the physical knobs (B1, B3) on spincube power’s front panel, or remotely from spinstudio.

Set output voltage locally

Output voltage can be set in two stages: coarse and fine setting. The actual range is always divided in 10:1 ratio between the coarse and fine knobs.
To set up output voltage without high voltage output activated, make sure that the high voltage is turned off.
Note: if the high voltage is turned on, press B3 High Voltage On button once.

1. Adjust B3 Fine Voltage Knob to the middle and seek the range with B1 Coarse Voltage Knob.
2. Use B2 knob to fine set the voltage.
3. Refer Activate High voltage to apply the set voltage on the emitter.

Set output voltage remotely

Note: for remote voltage setting, Remote Mode must be enabled first.

1. Make sure that spincube power interface was placed on spinstudio dashboard.
2. Output voltage can be either adjusted by rotating the Voltage knob of the interface, or by using the mouse wheel while the mouse pointer is above the Voltage knob.