For safety reasons, High Voltage can be only activated by physically pressing the button on the front panel of spincube power, this option is unavailable from spinstudio remote control. Activating…
Spinsplit spincube is factory limited to 80 uA output current. If the current between the collector and emitter exceeds this limit, the unit automatically reduces the output voltage. In this…
To adjust emitter-collector distance use C1 handwheel. To reduce distance, turn C1 hand-wheel clockwise. To increase distance, turn C1 hand-wheel anti-clockwise. For reference, one can use the built-in ruler to…
spincube system is equipped with a GigE camera which is accessible through the local network. Consider using wired access (not Wi-Fi) when transferring camera image. The camera unit is powered…
To turn on illumination, press Illumination button B7 once. To turn off illumination, press Illumination button B7 once.
To be able to set the voltage of the spincube power module from spinstudio, you have to enable remote control of the module in a two-step authentication fashion. Switch the…
Output voltage can be adjusted either by using the physical knobs (B1, B3) on spincube power’s front panel, or remotely from spinstudio. Set output voltage locally Output voltage can be…
With Hydrodrive one can dispense the precursor liquid directly from the syringe without using lengthy tubings and therefore creating dead volume. In this mode, the syringe is placed inside of…
CAUTION! – avoid using external syringes with emitter voltages above 20 kV. In such cases consider using the HydroDrive option instead. When using external syringes, the syringe is subjected to electrical…